Everlast Power Plasma 60

Everlast Plasma Cutters


PowerPlasma 60

Features & Benefits
- Easy starting with Pilot arc allows easy cutting of rusty and painted metals.
- Cuts virtually any type of metal with ease.
- Simple to use torches with inexpensive service parts and consumables.
- High duty cycle @ 60 % of rated amperage capacity.
- Exceptionally clean, smooth cuts.
- Adjustable Post Flow (power plasma only) control up to 60 seconds to improve consumable and torch life.
- Front air pressure adjustment makes adjusting pressure easy and painless. ( PowerPlasma only)
- Front air pressure gauge allows quick verification of air pressure.
- Over Current and Air Pressure light indicators keep you updated on your units operating condition.
- Suitable for use with 11,000 W "clean power" generat



Recommended Areas Of Use
- Cutting in all conditions where Oxy Fuel cutting is impractical, slow,
unsafe, expensive, or otherwise restricted or undesirable.
- Excellent choice for smooth cut requirements without warping
metal from high heat input typical of Oxy fuel torches.

Standard Equipment
- Torch, WDS-60P
- Consumable starter kit
- Water trap/filter
- Air pressure gauge

Optional Equipment
- Welding helmet
with special 7 shade for plasma cutting
- Consumable Kit
- Welding cart

Recommended Metals
- Virtually all types of metal




PAC - HF Start - With Pilot Arc

Input 220V-240V 1 Phase 50 Amps Max

Output: 20-60 Amps , 88-100 Volts

Duty Cycle  = 60% @ 60A, 100% @ 50A

Inverter Type - IBGT

Weight: 35 lbs.

Dimensions: 19"W X 31"L X 29"H

Protection Class: IP21S

Insulation Grade: F


Cutting Capacity

Clean Cut : 7/8"

Severance Cut : 1 1/8"